Steel coils and plates often lose more value in the first two weeks after discharge than they did in the previous two months of production. Most of that loss is avoidable, and it has nothing to do with the steel itself.
Why the first 14 days matter
A hot dip galvanized or cold rolled coil arrives with a thin, intact surface. Once the packing is opened, humidity, salt mist and temperature cycling start working on it immediately. In tropical ports the daily condensation cycle is enough to produce white rust on galvanized surfaces within days, and red rust on cold rolled edges within two to three weeks.
The buyer usually cannot avoid opening the container - customs and inspection require it. What can be controlled is what happens in the following hours.
Four things that cause most of the damage
Standing water under the coil. Coils stored on concrete without dunnage wick moisture from the floor. A 100 mm timber skid is not a detail, it is the difference between a clean coil and a rusted bottom wrap.
Stacking without edge protection. Two coils stacked directly on each other concentrate load on the wrap edge. The damage is invisible until the wrap is cut and the outer lap is found deformed.
Opening the packing and leaving it open. VCI film and desiccant work while they are sealed. Once cut, the protection is gone. If inspection requires opening, reseal the same day.
Salt mist at coastal yards. Within roughly 1 km of the sea, airborne chloride deposits on any exposed surface. Outdoor storage of cold rolled or galvanized product in a coastal yard is a countdown, not a storage decision.
A practical receiving checklist
- Photograph the container seals and the stow before unloading
- Check for condensation on the container ceiling - if the ceiling is wet, the top layer needs inspection first
- Store on timber or plastic dunnage, never directly on concrete or soil
- Keep coils on the roll, chocked, single row where weight allows
- Reseal opened packing the same day, with fresh desiccant if the original is saturated
- Record rust observations with date and location - this is what a claim needs
What we do before the container leaves
Packing is specified for the route, not for a generic export: VCI film or oiled surfaces, edge protectors, timber dunnage, steel strapping and shrink wrap on pallets. For hot and humid destinations we add desiccant and specify that the container lining stays intact until customs inspection at destination.
We also send a one-page receiving note with the documents, so the person at the port knows what to check first. It costs nothing and prevents most of the arguments that follow a rusty delivery.
Related products: Galvanized coil, Cold rolled coils, Hot rolled products
Frequently asked questions
How long before galvanized coil shows white rust?
In a humid port, white rust can appear on an unpacked galvanized coil within 3 to 10 days, depending on how often the surface condenses.
Should the container be opened immediately after discharge?
Open it when customs or inspection requires, but reseal the same day. VCI film and desiccant stop working once the wrap is cut.
Is dunnage really necessary indoors?
Yes. Concrete floors wick moisture into the bottom wrap. A 100 mm timber or plastic skid is enough to break that contact.

