
The same coil can be sold as hot rolled or cold rolled, and the two are not a quality ladder. They are different processes with different consequences for tolerances, surface, formability and price.
The process difference in one paragraph
Hot rolling happens above the recrystallisation temperature, around 900 °C and up. The steel is easy to deform, so thick sections and wide widths are cheap, but the surface carries scale and the thickness tolerance is looser. Cold rolling happens at room temperature on a much thinner input; the steel work-hardens, so it needs annealing to be formable again, and in exchange you get tight tolerances, a smooth surface and consistent mechanical properties.
Where the difference shows up
| Hot rolled | Cold rolled | |
|---|---|---|
| Thickness range | 1.2–200 mm (plate up to 400 mm) | 0.2–3.0 mm typically |
| Thickness tolerance | Looser, mill-dependent | Tight, often ±0.02–0.05 mm |
| Surface | Scale, may be pickled and oiled | Smooth, matte or bright |
| Formability | Good, but less consistent | Better after annealing; work-hardened if not |
| Cost per tonne | Lower | Higher by a meaningful margin |
| Typical use | Structure, heavy fabrication, pipe and tube input | Appliances, automotive, furniture, precision stamping |
How to choose
Choose hot rolled when the part is structural or when thickness matters more than finish. A bracket, a base plate, a chassis member: hot rolled, pickled and oiled if you need to weld or paint it without stripping scale.
Choose cold rolled when the part will be visible, stamped, or needs a consistent thickness for a forming operation. If you are producing 200,000 enclosures a year and the die gap is 0.9 mm, cold rolled at ±0.03 mm is not a luxury.
The mistake we see most often is a buyer specifying cold rolled for a part that is welded and painted, paying 15–25% more for a surface nobody will see. The second most common is specifying hot rolled for a progressive die, then fighting thickness variation.
Pickled and oiled: the middle option
Hot rolled pickled and oiled (HRPO) removes the oxide scale by acid pickling and applies a thin oil film. It welds and paints cleanly and costs less than cold rolled. If your issue is "the welds are contaminated by scale" rather than "the surface must be smooth", HRPO is usually the right answer.
How we supply flat products
- Hot rolled coil and sheet, as rolled or pickled and oiled, 1.2–25 mm
- Hot rolled plate to 200 mm, cut to size, with UT on request
- Cold rolled coil and sheet, annealed and skin-passed, 0.2–3.0 mm, in commercial, drawing and deep drawing grades
- Slitting, cut-to-length, edge trimming and protective film through our processing partners
- EN 10204 3.1 per heat, with mechanical properties reported for cold rolled
Tell us the part, the process and the annual volume. We will tell you which one you need, and where the cheaper option is genuinely safe.
Related products: Hot rolled products, Cold rolled products, S355J2+N plate
Related reading
Frequently asked questions
Can cold rolled steel replace hot rolled?
Only in thin gauges, typically up to 3 mm, and at roughly 15 to 25 percent higher cost. Beyond that it is not a commercial option.
What is pickled and oiled steel?
Hot rolled coil with the oxide scale removed by acid pickling and a thin oil film applied. It welds and paints cleanly and costs less than cold rolled.
Which is better for welding?
Hot rolled or pickled and oiled. Cold rolled is normally specified for forming and surface, not for heavy welding.


