
Two suppliers quote the same 10 mm S355 plate at 2,000 × 6,000 mm. One is 8% cheaper per tonne. Very often the difference is not price at all - it is the thickness the buyer is actually receiving, and which weight basis is written in the contract.
Theoretical weight vs actual weight
Mill certificates and shipping documents quote weight in one of two ways:
- Theoretical weight = length × width × nominal thickness × 7.85 t/m³. It is what the plate should weigh if it were exactly nominal.
- Actual weight = the weight on the scale. Always heavier or lighter than theoretical, depending on the rolling tolerance.
Mills are allowed to roll plate to a negative thickness tolerance, typically −0.3 mm on a 10 mm plate under EN 10029 or ASTM A6. If a supplier prices by theoretical weight but ships at the bottom of the tolerance, you receive about 3% less steel than you paid for. On 500 tonnes that is 15 tonnes.
The tolerance bands you should know
Under EN 10029, for thickness 8–15 mm and width up to 2,500 mm, the permissible negative deviation is around 0.3–0.5 mm, with the positive side symmetric. ASTM A6 allows a similar band. Neither is dishonest - it is industry standard. It only becomes a problem when the commercial basis is not written down.
| Basis in contract | What the buyer actually pays for |
|---|---|
| Theoretical weight, negative tolerance allowed | A number, not a mass. Expect 1–4% less steel |
| Actual (weighed) weight | What is on the scale at the port |
| Theoretical weight with negative tolerance capped at −0.3 mm | Predictable, small variance, standard practice |
| "Positive tolerance only" | More expensive, rarely available above 20 mm |
What to put in the contract
- State the basis explicitly - "theoretical weight, negative tolerance not exceeding 0.3 mm" or "actual weight per mill scale ticket".
- Require the thickness to be measured at the mid-point of the plate, away from the sheared edge, and reported on the certificate.
- Ask for the weighing list if you are buying FOB; the mill ticket and the port weight should be within 0.5%.
- Fix the tolerance on cut-to-length material too. Slitting and shearing do not change thickness, but a "nominal 10 mm" cut strip from a 9.7 mm plate is still 9.7 mm.
What we do
- Thickness and weight basis agreed in writing before the order is placed, not after the container is loaded
- Plate measured at the mid-point with a calibrated gauge before dispatch; readings recorded
- Theoretical weight quoted with the negative tolerance stated, or actual weight with the mill weigh ticket, whichever you prefer
- Third-party inspection can include thickness verification at random points across the bundle
- If you need a guaranteed minimum thickness, we will quote it and tell you the real cost, rather than quietly shipping to the bottom of the band
Send us the piece list and the standard you are buying to. We will tell you which weight basis makes sense for your project and what variance to expect, so nobody is surprised at the destination port.
Related products: S355J2+N steel plate, A516 Gr.70 steel plate, Hot rolled products
Related reading
Frequently asked questions
Why does my plate weigh less than the theoretical weight?
Because mills are allowed a negative thickness tolerance, around 0.3 mm on a 10 mm plate. If you buy on theoretical weight, that difference is yours.
What should the contract say about weight?
State the basis explicitly, either theoretical weight with a maximum negative deviation, or actual weight per mill scale ticket.
Is actual weight always better?
It is more predictable, but you pay for what is on the scale. Which basis suits you depends on how you resell or fabricate.


