Cut-to-Length or Full Plate: What Actually Saves Money

Nov 13, 2026

Leave a message

Cut-to-Length or Full Plate: What Actually Saves Money

Buyers often assume full plates are always cheaper per tonne. Per tonne, usually yes. Per finished part, often no - because the offcut is paid for twice: once as steel, once as freight, and a third time as scrap handling.

The arithmetic that decides it

Take a plate of 2,000 × 6,000 mm at 10 mm. That is 0.94 m³ of steel, about 7.4 tonnes. If your parts need 2,000 × 2,400 mm, you get two parts and 1,200 mm of offcut per plate - 20% waste before you have cut anything else.

Three things change the calculation:

  • Freight is charged on weight and volume. An offcut that ships to you and then to the scrap yard has been paid for twice.
  • Cutting is not free at destination. Plasma or laser time, handling and edge preparation often cost more than the mill's cut charge.
  • Nesting efficiency improves with mixed sizes. A mill that cuts several part sizes from one plate can nest better than a single-size order.

When full plates still win

  • You have your own nesting software and a shear or plasma table running below capacity
  • The offcuts are usable for other jobs
  • The plate is thin (under 6 mm), where handling a cut bundle costs more than the waste
  • You need a single heat number across a large area, for example a tank bottom

When cut-to-length wins

  • Parts are large and repeatable (base plates, flanges, gussets)
  • The destination has no cutting capacity, or cutting is expensive
  • Freight is a large share of landed cost - common for Africa and the Middle East
  • The order is project-specific, with no reuse for offcuts

What to ask for in a quotation

Ask for both: price per tonne for full plates, and price per piece for cut-to-length, with the nesting shown. A supplier who cannot show the nesting is guessing at the waste.

We quote cut-to-length with a simple nesting sheet: part sizes, pieces per plate, waste percentage, and the weight that will actually ship. When full plates are cheaper, we say so, because the cheaper option is the one that gets repeated.

Related: Hot rolled plate, Plate weight tolerance, Container loading

Frequently asked questions

Is cut-to-length more expensive per tonne?

Usually 3 to 8 percent more per tonne, but often cheaper per finished part once offcut freight and destination cutting are counted.

When are full plates the better buy?

When you have your own nesting, usable offcuts, or need one heat number across a large area.

How much waste is normal from a full plate?

For 2,400 mm parts from a 6,000 mm plate, expect around 20 percent before any other cutting.